HumanTechnik signolux Mode D'emploi page 12

We would like to congratulate you on pur-
chasing a »signolux«. You have chosen a
modern and reliable system. Kindly read the
user manual carefully in order to start using
the device properly and to familiarise your-
self with all the possibilities of the system.
Standard delivery scope
Kindly check if all following parts are
included:
– »signolux« receiver
– Doorbell- (Set 1) or call-pushbutton (Set 2)
– Battery (CR2032) for the doorbell
pushbutton
– 2 screw for the doorbell pushbutton
– Wall mount
– 2 screws for the »signolux« receiver
– 2 wall dowels
– Adhesive strips
– Operating manual
– Warranty card
Should any parts be missing, kindly contact
your specialist dealer or the manufacturer
directly.
Functioning principle
A »signolux« light signal system consists
of at least one transmitter (e.g. doorbell
pushbutton) ad a »signolux« receiver. Up to
8 transmitters can be integrated.
If e.g. the doorbell pushbutton is pressed, a
radio signal (radio impulses with 868 MHz)
are transmitted to the »signolux« receiver.
This one signals the received signals acous-
tically and visually with sounds and light
signals.
12 English
All manuals and user guides at all-guides.com
Safety instructions
– Prior to putting the device into operation
and using it, kindly read this manual thor-
oughly and in full.
– Store this operating manual in a safe place
so that it is also accessible for other users
at any time.
– When using power tools always follow the
instructions of the manufacturer and wear
suitable protective equipment (e.g. pro-
tective goggles).
– Kindly check before starting to drill if there
are any hidden electric cables and water
pipes in the walls. In case of doubt we
recommend using a a cable detector.
Commissioning
1. Set 1: (A-2621-0)
Inserting and replacing the battery
of the doorbell pushbutton
In order to be able to insert the coin cell
battery (type CR 2032) you first have to open
the battery compartment.
a) Place the doorbell pushbutton in such
a way on the work surface that the two
rotation axes of the transparent plastic
face are at the rear (fig. 1 A and C).
A
Figure 1: Doorbell pushbutton
C
B