Operation Auto-Change-Over - Jaga MINI FREESTANDING HYBRID Manuel D'installation Et D'utilisation

4.1. NOTIFICATIONS
Blue LEDs are flashing: the water temperature for cooling is too high
4 C
Red LEDs are flashing: the water temperature for heating is too low
Control panel error codes
LED flashes rapidly in the color of the set mode.
MODE MODE
5. OPERATION AUTO-CHANGE-OVER
Only in combination with a suitable heat
pump and control valve for heating and
cooling
2 C
The device automatically enters cooling mode when the water temperature is 2°C/4°F below the
room temperature. If the differential between room and water temperature is less than 1
device will automatically switch to standby. The unit starts at the last selected speed(1, 2 or 3), if the
water temperature < 24 ̊ C .
The unit is in standby. The unit automatically starts a new cycle if the preset temperature is
reached.
The device automatically enters heating mode when the water temperature is 4
room temperature. If the differential between room and water temperature is less than 1
than the room temperature, the device will automatically switch to standby. The unit starts at the last
selected speed(1, 2 or 3), if the water temperature > 28 ̊ C .
De breeze mode is switched on and off manually. The auto-change-over is disabled as long as the
breeze mode is active. The unit starts at the last selected speed (1, 2 of 3), regardless of the water
temperature.
JAGA N.V. | MINI FREESTANDING HYBRID | MANUEL | 2021.03.25 | V.01
2 C
Standby mode
Check the water temperature sensor
1 C
Standby mode
2 C
1 C
C/2°F, the
°
C/7°F above the
°
4 C
EN
4 C
C/2°F higher
°
31