Display Illumination; Adjusting Procedure For Flash Operating Modes; Ttl-Flash Modes - Metz MECABLITZ 58 AF-1 digital Mode D'emploi

707 47 0030.A3 03.03.2010

4 Display illumination

Every time a button on the flash unit is pressed, the flash display illumination is
activated for 10 seconds. When a flash is fired via the camera or a hand
release, the display lightning
5 Operating modes (mode menu)
Depending on camera type, various
TTL
without preflash, preflash, ADI flash control), Automatic
and Stroboscope . Therefore, data transfer between flash unit and camera is
necessary before setting the flash mode, e.g. by actuating the shutter release.
Depending on the type of camera, other flash modes may be supported.
These flash operating modes can be selected and activated in the mode
menu following a data transfer with the camera. Depending on the
system, some camera models (depending on the camera's operating
mode) only support the TTL flash mode. Other flash modes (automatic A,
manual M etc.) cannot be selected or activated!

5.1 Adjusting procedure for flash operating modes

• Press the „Mode" button until the word „Mode" appears on the display. You
can choose from the following operating modes:
TTL
TTL flash modes: Standard TTL without preflash, TTL preflash and ADI.
TTL
HSS TTL -flash mode with high speed synchronisation HSS
A
Automatic flash mode
M
Manual flash mode
M
HSS Manual flash mode with high speed synchronisation HSS
Stroboscope flash mode
• Set the flash mode of your choice (
using the UP and DOWN
lighted. The settings take effect immediately.
All manuals and user guides at all-guides.com
13:03 Uhr Seite 93
on the flash unit is switched off.
TTL
modes are available (Standard TTL
A
, Manual
TTL A M
, automatic , manual
keys. The flash mode you choose is then high-
• Press the „Return" button
view. If the „Return" button
the normal view after about 5 seconds.
The flash parameters for ISO, aperture and lens focal length or mirror position
are set automatically, if the camera transfers the necessary data to the flash unit.
The range indicator on the display of the control unit matches the flash parame-
ters transferred from the camera.
If the camera does not transfer one or more flash parameters to the flash
M
,
unit, you will have to adjust these settings by hand (see 6).

5.2 TTL-flash modes

The TTL flash modes offer a very simple method of achieving very good flash
shots. In these modes, exposure readings are taken by a sensor built into the
camera, which measures the amount of light through the camera lens
(TTL = „Through The Lens"). Here the camera automatically determines the flash
performance required for a correct exposure of the shot. The advantage of the
TTL flash modes is that all factors influencing exposure (filters, change of apertu-
re and focal length with zoom objectives, extensions for close-ups, etc.) are auto-
matically taken into account in adjusting the flash light.
If the shot was correctly lit, the correct exposure indication
about 3 seconds (see 4.2).
The flash unit automatically supports the camera's TTL flash mode. There is no
special indication of the flash mode.
Please note whether there are limitations for your camera in terms of film
sensitivity for TTL flash mode (for example, ISO 64 to ISO 1000; see
camera's operating instructions)! In analogue cameras there must be a
film in the camera to test the TTL function!
Preflash TTL and ADI metering
, etc.)
Preflash TTL and ADI metering are digital TTL flash operating modes and refined
versions of the TTL flash operation found in analogue cameras. When taking a
, and the display changes back to the normal
is not pressed, the display will change back to
will flash „OK" for
93