Wohler KM 410 Mode D'emploi page 49

6 Manual Recording
Fig. 11: Data record n° 20
6.1 Recall saved in-
formation
Fig. 12: Data record n° 23
Fig. 13: Showing the CO
record 23
The meter can record and recall 99 data records.

The main display and the REC icon will flash
about 3 seconds now. The main display shows
the memory serial number (at most 99 records).
Each memory contains all parameters (CO
TA ...%rh), not only the selected parameter
shown in the display.
The user can also press HOLD to freeze the read-
ing before manually recording the data. This will
make sense, if the reading changes quickly.
The manually recording function is disabled in the
min/max mode.




value of data
2
In normal measuring mode or in HOLD-mode,
press MEM to record the values.
NOTE!
NOTE!
In the normal measuring mode or in the HOLD
mode, press the MODE/RECALL key for more
than 2 seconds until the recall icon flashes.
The memory serial number of the last record
appears first and the reading appears after
that.
Press HOLD/▲ or MEM/▼ to scroll the rec-
ords.
Again the memory serial number of the record
appears first and the reading after that. (see
Abb. 13 and Abb. 14).
Manual Recording
, CO,
2
49
EN