Wohler KM 410 Mode D'emploi page 55

11.3 P30 Selection of
the temperature
unit
Fig. 20: Setup - Selection of the tempera-
ture unit
11.4 P40 Setting the
sampling rate
Fig. 21: Setup - Setting the sampling rate
Fig. 22: Setup - Setting the sampling rate
When entering the setup mode press HOLD sev-
eral times, to bring up the P30 mode for the selec-
tion of the temperature unit. "Unit" and P30 will
appear in the display.

Press M/AVG to select the temperature unit.

The current set and P 31 will appear on
screen.

Press HOLD/▲or MEM/▼ to choose °C (do
not delete) or °F.

Press M/AVG to save the settings or press
START/ESC to return to the P30 mode with-
out saving.
When entering the setup mode press HOLD sev-
eral times, to bring up the P40 mode. The user
can set a sampling rate from 1 second to 4 hours
59 minutes and 59 seconds.

Press M/AVG to bring up the setting mode.
The hour digits will blink.

Press HOLD/▲ to increase the value or
MEM/▼ to decrease.

Press M/AVG to save the settings and bring
up the mode for setting the minutes.

Proceed the same way when setting the sec-
onds.

Press M/AVG to save the settings and to
return to the P40 mode.
Settings
EN
55