Operating Instructions; Controls; Fan Speed - Friedrich Thru-the-Wall Serie Guide D'installation Et De Fonctionnement

Operating Instructions

Controls

TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of
hours until shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 2°F after 30 min.,
and once again after another 30 min.
• Push Timer button to advance setting from
1 Hour 2 Hours
- START TIME
• If unit is off, use Timer to set number of hours
before unit starts.
• Push Timer button to advance setting from
1 Hour 2 Hours
MODE
- Push this button to shift mode of operation from COOL
- COOL :
• Fan runs continually for normal cooling operation.
- MONEY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on
and the unit will check the room air to determine if cooling is needed.
- FAN :
• Fan-only operation.
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its previous setting.
F1 LOW
F2 MED
F3 HIGH
....
12 Hours maximum.
.....
12 Hours maximum.
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range
of 60°F to 86°F by increments of 1°F.
• The setting appears in the display.
POWER
• To turn the air conditioner ON, push this
button.
To turn the air conditioner OFF, push the
button again.
• This button takes priority over any other
button.
• When you first turn it on, the unit is in
cool mode, at High fan speed, and set at
a temperature setting of 72°F.

FAN SPEED

• Every time you push this button, it
advances the setting as follows:
{High Low Med
MONEY SAVER
6
High}
FAN.