How To Operate Your Friedrich; Inserting The Remote Control Batteries - Friedrich CP Line CP08 Manuel D'utilisation Et D'installation

How to operate your Friedrich

3 5
Control and Remote Control Operations
1. POWER
Operation begins when this button is pressed
and stops when you press the button again.
2. TEMPERATURE CONTROL
The thermostat monitors room temperature
to maintain the desired temperature.
The thermostat can be set between
60°F~86°F (16°C~30°C).
The unit takes an average of 30 minutes to
adjust the room temperature by 1°F.
3. OPERATION MODE SELECTOR
Select cooling mode to cool the room.
Select Money Saver® mode for energy
saving operation.
Select fan mode for basic ventilating fan
operation.
Select dry mode for dry operation.

Inserting the Remote Control Batteries

1. Push out the cover on the back
of the remote control with your
thumb
2. Pay attention to polarity and
insert two new AAA 1.5V
batteries.
3. Reattach the cover.
2 6
4 1
4. FAN SPEED SELECTOR
5. ON/OFF TIMER
6. REMOTE CONTROL SENSOR
NOTE: Do not use rechargeable batteries. Make sure that
both batteries are new.
• In order to prevent discharge, remove the batteries from
the remote control if the air conditioner is not going to be
used for an extended period of time
Keep the remote control away from extremely hot or
humid places.
To maintain optimal operation of the remote control, the
remote sensor should not be exposed to direct sunlight.
• The remote control can be mounted on a wall using the
mountable holder.(Friedrich does not provide this.)
5
Power
Temp
Fan Speed
Timer Mode
5
For increased power while cooling, select a
higher fan speed.
3 steps: High; Low; Med
The timer can be set to start and stop the
unit in hourly increments (up to 12 hours).
7
1
2
4
3