Kessel Staufix FKA Instructions D'installation Et D'utilisation page 44

5.1 Acknowledge alarm
The control unit displays (alarm) messages as follows:
the alarm LED flashes red,
an error message appears in the display,
an acoustic signal sounds.
Press the Alarm button for 3 seconds to acknowledge.
If the cause of the error has been corrected, the acoustic
signal falls silent and the LED stops flashing.
Pressing the Alarm button briefly switches off the acoustic
alarm; however, the error message remains in the display
and flashes.
5.2 To put into service, proceed as follows:
CAUTION
If the control unit is used as a redundant control unit,
to fulfil its function it must be connected via an elec-
tric circuit separate from the hybrid lifting station.
Plug in the mains plug.
All LEDs light up, one after the other.
|Menu 0 System info|
Check whether
(Indicates a successful system test.)
Power LED (green) indicates standby state (ready for
operation).
44 / 164
If the control unit has not yet been initialised it starts the
initialisation automatically.
appears.
016-003