Adjusting Initial Settings; Setting The Clock; Switching The Auxiliary Setting - Pioneer SUPER TUNER III D DEH-P860MP Mode D'emploi

Section
12 Initial Settings

Adjusting initial settings

1
Initial settings lets you perform initial setup of
different settings for this unit.
1 Function name tag
Shows the function currently selected in
highlighted manner.
2 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
the clock appears in the display.
3 Turn MULTI-CONTROL to select one of
the initial settings.
Turn MULTI-CONTROL clockwise to switch be-
tween the functions in the following order:
CLOCK (clock)AUX (auxiliary input)DIM
(dimmer)BRIGHT (brightness)D.ATT (digi-
tal attenuator)MUTE (telephone muting/at-
tenuation)WARN (warning tone)DEMO
(feature demo)REV (reverse mode)FONT
(font)SCROLL (ever scroll)AUTO OPEN
(flap auto open)
# You can also switch between the functions in
the reverse order by turning MULTI-CONTROL
counterclockwise.
# To cancel initial settings, press BAND/ESC.
62
En
2

Setting the clock

Use these instructions to set the clock.
1 Use MULTI-CONTROL to select CLOCK.
The function name tag CLOCK is highlighted.
2 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing MULTI-CONTROL left or right will se-
lect one segment of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Push MULTI-CONTROL up or down to
set the clock.
Pushing MULTI-CONTROL up will increase
the selected hour or minute. Pushing
MULTI-CONTROL down will decrease the se-
lected hour or minute.
Note
You can match the clock to a time signal by
pressing MULTI-CONTROL.
! If the minute is 0029, the minutes are
rounded down. (e.g., 10:18 becomes 10:00.)
! If the minute is 3059, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)

Switching the auxiliary setting

It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.