Section
11
Audio Adjustments
4
Push MULTI-CONTROL left or right to
select cut-off frequency.
Each pushing MULTI-CONTROL left or right
selects cut-off frequencies in the following
order:
506380100125160200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the rear speak-
ers.
5
Push MULTI-CONTROL up or down to
adjust the output level of the rear speak-
ers.
Each pushing MULTI-CONTROL up or down
increases or decreases the level of the rear
speakers. ±0 24 is displayed as the level is
increased or decreased.
Using the auto-equalizer
The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on page 59).
You can turn the auto-equalizer on or off.
1
Use MULTI-CONTROL to select
AUTO-EQ.
The function name tag AUTO-EQ is high-
lighted.
# Please set Auto EQ appears. This indicates
that you cannot turn the auto-equalizer on if auto
TA and EQ has not been carried out.
2
Press MULTI-CONTROL to turn the auto-
equalizer on.
Auto EQ ON appears in the display.
# To turn auto-equalizer off, press
MULTI-CONTROL again.
56
En
Recalling equalizer curves
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display
Equalizer curve
POWERFUL
Powerful
NATURAL
Natural
VOCAL
Vocal
FLAT
Flat
CUSTOM1
Custom 1
CUSTOM2
Custom 2
SUPER BASS
Super bass
! CUSTOM1 and CUSTOM2 are adjusted
equalizer curves that you create. Adjust-
ments can be made with a 13-band graphic
equalizer.
! When FLAT is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
SUPER BASSPOWERFULNATURAL
VOCALFLATCUSTOM1CUSTOM2
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of FLAT, can be adjusted to a fine
degree (nuance control).