Skil 7510 Consignes De Fonctionnement/Sécurité page 8

SM 2610019941 08-11:SM 2610019941 08-11.qxp 8/15/11 9:07 AM Page 8
REMOVING AND INSTALLING
SANDING BELTS
To prevent personal injury,
WARNING
always disconnect the plug
from the power source before removing or
installing the belt.
Keep your fingers and clothing away from
the belt. They could get cut or wedged
between the pulley, belt and motor housing.
TO REMOVE BELT
1. Place sander on it's side and move lever in
direction of arrow to retract front pulley and
release belt tension (Fig. 2).
FIG. 2
REAR PULLEY
DIRECTION OF
TRAVEL
MICROFILTER DUST CANISTER
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
Your tool is equipped with a
WARNING
dust canister, empty it
frequently, after completion of sanding and
before storing the sander. Be extremely
careful of dust disposal, materials in fine
particle form may be explosive. Do not throw
sanding dust on an open fire. Combustion
from mixture of varnishes, lacquers,
polyurethane, oil or water with dust particles
can occur if there is a static discharge, spark
introduced in the box, or excessive heat.
Assembly
2. With the sander on it's side and the open
side facing you, you can easily remove the belt.
TO INSTALL BELT
1. While the sander is still on it's side with the
front pulley retracted and locked, insert the new
belt around both pulleys and over the metal
plate. If belt has directional marks, be sure the
arrow on the inside of belt is pointing in the
direction of rotation as indicated on housing.
2. Then push lever back to its original position
to return tension to the belt.
BELT TENSION
RELEASE LEVER
REMOVING AND INSTALLING DUST
To remove dust canister, simply pull away
from the tool (Fig. 3).
To install dust canister, align dust port tab
with slot in canister and push canister onto
tool.
CLEANING AND EMPTYING
THE DUST CANISTER
Remove canister from tool and knock excess
dust out of the microfilter, or remove dust
with your fingers or a soft brush. You may
notice that all the dust may not come out of
the canister. This will not affect sanding
performance but will reduce dust collection
efficiency.
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
-8-
METAL
PLATE
CANISTER