Sanding Tips - Skil 7510 Consignes De Fonctionnement/Sécurité

SM 2610019941 08-11:SM 2610019941 08-11.qxp 8/15/11 9:07 AM Page 11
TYPE OF MATERIAL
WOOD FINISHING:
New or unfinished
wood, plastics, resins.
NON-FERROUS
METALS: Such as lead,
copper, solder and
aluminum.
PAINT REMOVING:
For removing varnish,
lacquer and paint,
also for resinous or
green wood.
FLUSH SANDING
Your sander has been designed to allow
convenient flush sanding on the right side of
the sander.

Sanding Tips

TECHNIQUE
Grasp the handles firmly. Start the sander with
the belt off the work (NOTE: never start or stop
the tool with the belt in contact with the work
surface). Place the heel of the sander on the
work first. Then, with a forward motion, begin
the sanding stroke as the machine is lowered
onto the work surface. This will prevent
gouging. Keep the sander moving so that your
work will be smooth and even. The stroke is
simply a back-and-forth movement with most of
the sanding done on the pull movement. Use a
light touch. The weight of the belt sander is the
only pressure required. Too much pressure will
slow the work by overloading the motor and
reducing belt speed. The result will be
decreased sanding efficiency. Sand slowly and
systematically and, when you stop, lift the
sander from the surface before stopping the
tool.
3" x 18" BELTS AVAILABLE FROM SKIL
REMARKS
This is a "closed
coat" belt and has a
white colored
backing for
identification. The
abrasive used is
aluminum oxide.
Similar to above
belts but "open
coat". Aluminum
oxide grits
are wider apart.
2 Belts per package
Take care to select belts wisely. For initial
smoothing of rough lumber, use coarse or very
coarse grit and sand with the grain. On very
uneven or hard wood, sand diagonally (across
the grain). Be careful to avoid gouging. Now
switch to medium grit belt and sand with the
grain. This will provide a relatively level and
smooth finish. Now insert a fine grit belt for final
finishing. Always sand with the grain to remove
scratches left by coarser belts. Keep the
sander moving in long, light strokes during
finishing operations. As a final touch,
experienced sanders will often insert a "used"
fine belt to provide a smooth surface for filling,
sealing, brushing or spraying.
Your belt sander will also help remove old
paint, varnish or lacquer; however, if the
coating consists of several layers, remove as
much as possible with a paint solvent or
varnish remover before using the belt sander.
Use a hand scraper to remove the residue left
by the solvent and allow surface to dry
completely before sanding.
-11-
GRIT SIZE
Coarse Medium Fine
40
60
Grit Grit
Grit
No. No.
No.
73105 73107
73106
40 60
Grit Grit
No. No.
73105 73106
WOOD FINISHING
REFINISHING COATED WOOD
Very Fine
80 100 Grit
No.
73108
120 Grit
No.
73109