Skil 7510 Consignes De Fonctionnement/Sécurité page 12

SM 2610019941 08-11:SM 2610019941 08-11.qxp 8/15/11 9:07 AM Page 12
For fast removal, start with a coarse grit, open
coat belt. Change to closed coat belts, using
medium grits as the material shows through the
coating. When the covering is thin, use medium
grit to avoid scratching the material. Use short,
light strokes, moving the sander rapidly.
Excessive pressure or steady sanding in one
place will burn the coating and load the belt.
METAL FINISHING
For ferrous metals such as steel, stainless
steel, iron, etc., use coarse grit open coat belts
SANDING
OPERATION
ROUGH
PREPARATORY
FINISH
Remove all sanding dust thoroughly before coating. Use a soft brush or a vacuum cleaner
and hose to remove all dust from seams or crevices.
Read instruction manual first! Remove plug from the power source before
WARNING
making adjustments or assembling accessories.
TROUBLE: TOOL WILL NOT START
PROBLEM
1. Power cord is not plugged in.
2. Power source fuse or circuit breaker tripped.
3. Cord damaged.
4. Burned out switch.
REMEDY
1. Plug tool into power source.
2. Replace fuse or reset tripped circuit breaker. (If the product repeatedly causes
the circuit or fuse to trip/blow, discontinue use immediately and have it serviced by
an Authorized Skil Service Center or Service Station.)
3. Inspect cord for damage. If damaged, have cord replaced by an Authorized Skil
Service Center or Service Station.
4. Have switch replaced by an Authorized Skil Service Center or Service Station.
TROUBLE: TOOL DOES NOT COME UP TO SPEED
PROBLEM
1. Extension cord has insufficient gauge or is too long.
2. Low house voltage.
REMEDY
1. Replace with adequate extension cord (Page 13).
2. Contact your electric company.
GUIDE FOR WOOD SANDING OPERATION
PURPOSE ABRASIVE
TO USE
To level out uneven Open Coat
surfaces. Coarse Grit
Open Coat
To smooth the
Medium Grit
rough sanding
preparatory to finish
sanding.
The last sanding in Open or
preparing the bare Closed Coat
wood for coating. Fine Grit
Trouble Shooting
-12-
or coarse to fine grit closed coat belts,
depending on the finish desired. Non-ferrous
metals such as aluminum, solder, brass,
bronze, etc., can also be sanded. Beeswax or
tallow are recommended as lubricants for metal
sanding, polishing or satin finishing to minimize
belt loading and to lengthen belt life. To use,
simply rub the lubricant on the belt from time to
time. SAE No. 10 or 20 lubricating oil can also
be used to assure a smooth scratch free
surface. Just wipe the oil on the surface prior to
sanding.
METHOD OF SANDING
Sanding diagonally to start
and finish up sanding
parallel with the grain.
Sanding parallel with the
wood grain.
Sanding parallel with the
wood grain.