Quick Start Guide; Diaper/Nappy Fitment - Snuza go! Manuel D'utilisation

4. QUICK START GUIDE

1. Important: Use the correct diaper size and make sure it fits snugly (see
2. Switch on by briefly pressing the ON/OFF button (5).
3. A start-up test will illuminate the indicator lights, play the start-up tone and
4. Clip Snuza Go! onto the diaper so that the Movement Sensor (1) is in direct
5. The Movement Indicator Light (3) flashes on each abdominal movement.
6. If no abdominal movement is detected for a period of 20 seconds, the full
7. The alarm can be deactivated by briefly pressing the MODE/OFF button (6)
8. To turn off the monitor, press both the ON/OFF (5) and MODE/OFF (6)

5. DIAPER/NAPPY FITMENT

Important: Correct diaper fitment is essential for the
operation of Go!. The thin flap of material at the top of
the diaper must be folded over the thicker part before
the diaper is closed (this is the section to which Snuza
Go! will be attached). The diaper should fit snugly on the
baby with the top of the diaper just below the belly
button. Loose fitting diapers will gape, causing the
monitor to lose contact with the baby and false alarm. A
very 'full' or wet diaper may also cause it to gape.
Go manual-USA_10.14.indd 6
Section 5 Diaper/Nappy Fitment).
perform a battery test.
contact with the baby's skin in the tummy area (see Section 6 Fitting your
Go!).
See Section 7.2 Monitoring for a full description of what it signifies.
audible alarm will sound and the Movement Indicator Light (3) will flash
red. See Section 8.2 Alarm Activation Period for a description of how to
reduce the time period to 15 or 18 seconds.
and monitoring will continue.
buttons simultaneously. A shutdown tone will be heard.
6
2014/11/11 12:36 PM