Fitting Your Go; Operation; Startup - Snuza go! Manuel D'utilisation

6. FITTING YOUR GO!

Ensure that the Battery Cover (8) is secure. Clip your Go! all the way onto the
diaper to the full extent of the clip, as shown:-

7. OPERATION

7.1 Startup

Switch on by briefly pressing the ON/OFF button (5).
A startup-test will run which will flash all indicator lights and briefly sound the
audible alarm.
The Battery Indicator Light (2) will flash briefly as follows:-
Green
Orange Battery nearing depletion – replace battery
Red
Warning: Ensure that indicator lights and alarm are working properly and that
the battery level is high enough for proper operation (i.e. green or orange
light). Otherwise, DO NOT use the monitor. If the battery is too flat to
operate, the Battery Indicator Light (2) will flash red accompanied by a short
Go manual-USA_10.14.indd 7
Battery OK
Battery flat – Go! will not monitor, replace battery
Make sure that the Movement
Sensor (1) is in contact with the
baby's tummy around the belly
button area, although closer to
the sides may suit different
sleeping positions.
The World Health Organisation
(WHO) recommends that
babies be placed to sleep on
their back unless advised
otherwise by a doctor.
7
2014/11/11 12:36 PM