Travelling; Clothing; Baby Sound And Video Monitors; Settings - Snuza go! Manuel D'utilisation

7.3 Travelling

Movement from external sources such as being pushed in a pram or traveling
in a vehicle or aircraft may be detected by Go!'s sensor. Snuza Go! should not
be relied upon where external sources of movement are present.

7.4 Clothing

• Go! can be clipped onto the folded waistband of the diaper or the
waistband of elasticated pants, as long as the Movement Sensor (1)
touches the baby in the tummy area.
• There may also be a thin layer of clothing (eg a vest) between the
Sensor and the skin, but ensure that the Sensor maintains contact.
• The monitor can also be used if baby is dressed in light clothing (for
example, a Babygro) over the diaper or pants to which the Go! is
attached.
• Too much clothing may attenuate or muffle the alarm. Make sure the
alarm can be heard if baby is covered in clothing and/or blankets.
7.5 Baby Sound and Video Monitors (Optional)
Snuza Go! can be used together with a baby sound or video monitor to extend
the distance at which the alarm can be heard.

8. SETTINGS

8.1 Audible Tick

This feature causes Go! to emit an audible 'tick' on each abdominal
movement. To enable the Audible tick, ensure that Go! is switched ON, and
press the MODE/OFF button (6) briefly (less than 1 second).
To increase the volume of the tick, press the MODE/OFF button once again for
medium volume and again for high volume.
To turn off, briefly press the MODE/OFF button a fourth time – Go! will give a
louder beep.
Go manual-USA_10.14.indd 9
9
2014/11/11 12:36 PM