To disable this warning during monitoring, ensure that Go! is switched ON, and
press and hold the MODE/OFF button (6) for more than 1 second until the unit
beeps.
If you want to enable the warning again, switch Go! off completely (press both
ON/OFF (5) and MODE/OFF (6) buttons simultaneously), then switch it ON
again. The Movement-rate Warning is enabled by default when Go! is
switched on.
9. BATTERY
9.1 Battery Indicator
If the battery becomes depleted during monitoring, the Battery Indicator Light
(2) will flash as follows:-
♪
If the battery is nearing depletion or depleted, change the battery before
further use of the monitor (see Section 9.3 Replacing the Battery).
9.2 Battery Life
The life of the replaceable battery depends entirely on usage. Battery life will
vary significantly depending on the average daily duration of use and/or alarm
duration and/or number of alarms. Turning on and off unnecessarily shortens
the battery life. If the number of alarms is high, check diaper fitment.
Please note that the product guarantee does not apply to the battery.
Go manual-USA_10.14.indd 11
Red flash on each abdominal
movement
Red flash on each abdominal
movement and the low battery will take place. Replace battery
alarm beeps every 2 seconds
Nearing depletion – replace
battery before further use.
Battery flat – no monitoring
before further use.
11
2014/11/11 12:36 PM