Publicité
Les langues disponibles
Les langues disponibles
absorbed into the surrounding air. The refrigerator cabinet
does not therefore require de-frosting, but only proper cleaning
instead.
∙ To enable the melt-water to drain freely, always ensure that
the channel and discharge opening in the cabinet are free of
any blockage.
Energy saving tips
∙ The appliance should be set up in a well-ventilated, dry
room.
∙ Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc.).
If this cannot be avoided, however, suitable insulation must be
installed between the heat source and the unit.
∙ Ensure suffi cient air circulation around the unit.
∙ The compressor (at the rear) should be cleaned at regular
intervals. Accumulated dust causes an increase in energy
consumption.
∙ Warm food should be allowed to cool down before it is
stored inside.
Problem
The appliance is not working at all.
The temperature inside the freezer
compartment is not low enough.
The normal operating sound changes or
becomes louder.
Water is collecting on the bottom of the unit.
18
All manuals and user guides at all-guides.com
∙ To prevent an increased build-up of ice, do not leave the
∙ Frequent de-frosting helps to save energy. For detailed
∙ Do not set a lower-than-necessary temperature. For detailed
Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are:
∙ caused by the
∙ caused by the cooling agent fl owing through the circuit.
The following table lists possible malfunctions and their
probable causes and solutions. In the event of operational
p roblems, check fi rst whether a solution can be found using this
table. If the problem persists, disconnect the appliance from the
mains power and contact our Customer Service Department.
Possible cause and solution
∙ There is a power failure
∙ The main fuse has blown.
∙ The temperature control is set to '0'.
∙ The fuse in the wall socket (if applicable) has blown. This can be checked by
connecting another electrical device to the socket and checking for function.
∙ Too much food has been stored in the appliance.
∙ The doors are not properly closed.
∙ There is too much dust on the condenser.
∙ Insuffi cient ventilation: the unit is too close to a wall or other structure or object.
∙ The temperature control is set too low.
∙ Check for proper positioning (uneven fl oor?).
∙ Are any adjacent objects affected by the running of the cooling unit (i.e. causing
them to vibrate?)
∙ Are there any objects on top of the unit which might be vibrating?
The melt-water drain system is blocked. Remove the blockage and clean the
system.
doors of the unit open for too long when loading or taking
out food.
information on cleaning the appliance, please refer to the
section De-frosting and cleaning.
information on the temperature settings, please refer to the
section Temperature control.
electrical motor within
the compressor
assembly; during
compressor start-up
the sound level will be
slightly higher for a
limited period of time.
Publicité
