SEVERIN KS 9783 Mode D'emploi page 14

8. Door storage
9. Bottle storage
Before using for the fi rst time
∙ Remove any exterior and interior packaging materials
completely, including the adhesive strips.
∙ The packaging materials must be properly disposed of.
∙ Before it is connected to the mains, the unit must be
thoroughly checked for transport damage, including its
power cord.
∙ Clean the unit as described in the section De-frosting and
cleaning.
∙ For positioning, we recommend that you tilt the unit slightly
backwards. In this way, the transport rollers can be used to
move it to its intended place of installation.
∙ The unit should only be transported in its vertical position;
do not tilt any more than 30°.
∙ Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
∙ If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
∙ When the unit is fi rst switched on, a slight 'new' smell may
be noticed. However, this will disappear once the cooling
process has begun.
Installation
∙ The appliance should be set up in a well-ventilated, dry room.
∙ It should be operated in conditions where the relative
humidity is no more than 70 %.
∙ The product data sheet contains details of the ambient
temperature range suitable for this appliance.
∙ Do not use the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed from
the wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc). If
this cannot be avoided, however, suitable insulation must be in
installed between the heat source and the unit.
∙ The unit must not be installed inside a cabinet, nor directly
below a hanging cupboard, shelf or similar object.
Ventilation
Ensure that there is enough space
around the unit so that the air
circulation round and behind it is
not obstructed. (Rear, sides and
top 10 cm.)
Caution: Ensure at all times that
the rear ventilation openings
around the top cover are not
obstructed.
∙ In the case of uneven fl oors,
the adjustable feet on the unit
can be used to compensate and
ensure optimum stability.
∙ Ensure that the door can swing
open to an angle of 160°.
14
All manuals and user guides at all-guides.com
Reversible door
If required, the door may be reversed, i.e. from right-hinged (default
installation) to left-hinged.
To avoid the risk of personal injury or damage to the unit, two
people are needed to reverse the door.
Warning: Always disconnect the unit from the mains before
any maintenance or repair work is carried out.
Before reversing the door, tip the whole unit rearwards until it is
resting on its back. However, ensure that it is resting on a soft,
smooth surface to prevent any damage to the unit.
Before you start, please note the following:
∙ Always ensure that the correct number of washers is
∙ So that the doors can close tightly against the frame,
1.
2.
used on all hinge bolts and screws.
take the utmost care that they are properly aligned
during re-assembly.
Remove the screw covers from the top cover.
Take out the screws and remove the entire top cover.