Electronic Control - Gram FS Mode D'emploi

GB
should then give correct earthing. If in
doubt, approach your local supplier or
authorised electrician.
WARNING
The flexible cord fitted to this appliance
has three cores for use with a 3-pin 13-
amp or 3-pin 15-amp plug. If a B.S. 1363
(13-amp) fused plug is used, it should be
fitted with a 13-amp fuse.
IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead
of this appliance might not correspond with
the colour marking wich identify the termi-
nals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW wire
to the plug terminal marked "E" or by an
earth symbol, or coloured GREEN or GRE-
EN-AND-YELLOW. Connect the BLUE
wire to the plug terminal marked "N" or col-
oured BLACK. Connect the BROWN wire
to the plug terminal marked "L" or coloured
RED.
You can change the
door from righthand to
lefthand - hinged or
vice versa yourself
Illustration shows how easy it is to
3
change the door from righthand to left-
hand-hinged - or vice versa.
Lay the cabinet on its back with door
uppermost.
Take off the door handle
driver.
To take off the door, remove the screws
with a key.
40
All manuals and user guides at all-guides.com
When the door is removed, one hinge re-
mains attached to the door. This hinge must
be removed before the door is refitted.
Move the hinge pin
Note that the pin must be fitted for the "op-
posite hand", i.e. it must be turned 1/4 of a
turn (see drg C). It might be necessary to
use pliers to draw the pin out from the top.
Move the dummy hinge and (with a knife)
the screw caps on the top and bottom of
the door
Now place the door and fit the hinge ac-
companying the freezer where the dummy
hinge was fastened.
When refitting the door, a 9 mm packer
(wood or similar material) should be inser-
ted at the lower hinge, between the front of
the cabinet and the door edge, to create
sufficient clearance for the sealing strip.
Remember to place the correct number of
washers beneath the lower hinge to ensure
that the door is at the correct height.
Refit the door handle.
Starting up
If during transport the freezer has been laid
down, or if it has been stored in cold sur-
roundings (colder than +5°C) it must be
allowed to stabilise for at least 1 hour befo-
re switching on.
Start the freezer by plugging the lead into a
wall socket.
When the freezer is connected an alarm
will indicate that it is too warm and that the-
re has just been a power failure. See
"Alarm" for the instruction on switching off
the alarm.

Electronic control

Illustration
ting panel.
The electronically controlled freezer is fac-
1
using screw-
tory set to run at the optimum temperatu-
res and can be operated with the keys
2
"TEMP."
3 to the opposite side.
4
to the opposite side.
shows the electronic opera-
4
and "FREEZE"
5 6
.