Control Panel; Temperature Control - Gram FS Mode D'emploi

GB
accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead
of this appliance might not correspond with
the colour markings identifying the termi-
nals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW wire
to the plug terminal marked by "E" or an
earth symbol, or coloured GREEN or
GREEN-AND-YELLOW. Connect the blue
wire to the plug terminal marked "N" or
coloured BLACK.
Connect the BROWN wire to the plug ter-
minal marked "L" or colored RED.

Control panel

4
The control panel
righthand of the cabinet.
11
The alarm lamp is located at the top
and is visible through a small pane in the
door emblem.
The red alarm lamp will remain on while
the cabinet temperature is satisfactory. If
the cabinet temperature does not corre-
spond to that of the thermostat setting the
red alarm lamp will flash.
A "Quick-freeze" switch
under the alarm lamp. See section on fre-
ezing.
NOTE!
When fresh products are placed in the
cabinet the temperature rise will be enough
to make the red alarm lamp flash, but it will
stop flashing when the temperature drops
to below approximately -15°C again.

Temperature control

The cabinet is started by setting the tempe-
rature control knob
13
regulating range. After a couple of hours
All manuals and user guides at all-guides.com
is located at the top
12
is located
in the middle of the
the cabinet temperature will have fallen to
correspond with the thermostat setting.
If you require an even lower temperature,
turn the regulating knob towards "Max.".
If, on the other hand, you require a higher
temperature, turn the regulating knob a litt-
le towards "0", again waiting some time for
temperature conditions to stabilize.
How to use the freezer
The entire cabinet can be used for freezing
and for the long-term storage of frozen pro-
duce.
The upper freezing shelf is fitted with an
adjustable tilt-out guard that allows
produce to be stored at the very front of
the shelf.
Freezing
To obtain the most efficient freezing, press
the Quick-freeze switch
before products are to be placed in the
cabinet. The switch will flash yellow when
Quick-freeze is in operation.
Produce for freezing must be packed in
suitable wrapping material and placed in
contact with the plate shelves. During
freezing, the packs should be swapped
with other packs that have not been in con-
tact with the plate shelf freezing element.
When freezing is complete - after 24 to 48
hours, depending on the quantity frozen -
switch off the Quick-freeze switch. The yel-
low lamp will then stop flashing.
NOTE! During freezing, the compressor
will run constantly.
Defrosting
Frost should be removed when it becomes
more than 1/2 cm thick. Never use a sharp
or pointed object that might damage the
4
24 hours
12
31