GETTING STARTED
Make sure that your household power supply has AC230V ~ 50Hz and
connect the mains plug to the mains.
BACKUP BATTERY
With this function, the clock continues to run internally (indicator does not light
up) or the set alarm time and stored stations are retained in the event of a
power failure. The display does not light up until the power supply is available
again. Insert a 3V CR2032 button cell into the battery compartment with the
correct polarity.
TIME AND CALENDAR SETTING
Press and hold the M + key (6) until the display flashes. By pressing the M +
key again, you can choose between the following settings.
Year → Month / Day → Hours / Minutes → Normal Mode
-
<< / >> button (3/5) setting year
-
<< button (3) Setting month / hours
-
>> button (5) Setting day / minutes
-
After setting, press the M + button (6).
ALARM 1 and ALARM 2 SETTING
Note:
Wake up with radio: Make sure you have set the desired radio frequency in
advance.
1. In standby mode, press and hold the AL1 button (1) until the display
flashes.
2. After you are in setting mode, you can switch between the following
settings with the AL1 key (1) and set each with the << >> (3/5) keys.
AL 1 hour / minutes (with buttons << = hours, >> minutes set) → AL 1 Wake up
mode (radio / beep) → AL 1 select weekdays (with buttons << / >> (3/5)) →
Normal mode.
UR8400 / English Instruction Manual