Safety Notices For Chargers; Advice On Use; Before Use; Removing / Charging / Inserting The Battery Pack - Parkside PAMFW 10.8 A1 Instructions D'utilisation Et Consignes De Sécurité

General safety advice for electrical power tools / Before use
services providers. Contact with electricity
cables can lead to fire or electric shock.
Damaging a gas pipe can lead to an explo-
sion. Penetration of a water pipe can lead to
property damage or to electric shock.
I f you use the device outdoors, always
connect it through a residual current
device (RCD) with a maximum trip
current of 30 mA. If using an extension lead,
always use one that is approved for outdoor use.
Any harmful / noxious dusts
generated from sanding represent a risk to the
health of the person operating the device and
to anyone near the work area.
Wear safety glasses and a dust pro-
tection mask!
E nsure that there is adequate ventila-
tion when working on plastic, paint,
varnish etc.
D o not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.

Safety notices for chargers

T his appliance can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction con-
cerning use of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made by
children without supervision.
For indoor use only!
Protect the battery against
heat, e.g., against continuous
intense sunlight, fire, water
and moisture.
Danger of explosion.
10 GB/IE
All manuals and user guides at all-guides.com
Principle of operation:
The oscillating motor allows the application tool to
oscillate back and forth 5000 to 19000 times per
minute. This allows for accurate working in the tight-
est of spaces.
Sawing / cutting:
Sanding:
NOTE: The battery pack is delivered partly charged.
Charge the rechargeable battery in the charging
station for at least 1 hour before first use. This will
ensure the battery delivers full power. Li-Ion batteries
can be charged at any time without reducing the life.
Interrupting the charging process does not damage
the rechargeable battery.
1. To remove the battery pack
2. Insert the rechargeable battery pack
3. Insert the mains plug into the mains socket. The
4. The green charging status LED
5. Slide the battery pack

Advice on use

U se only undamaged, defect-free saw blades.
Distorted, blunt or otherwise damaged saw
blades could break.
W hen sawing lightweight building materials,
observe the statutory requirements and the
manufacturer's recommendations.
U se the device in plunge sawing mode on soft
materials such as wood, gypsum plaster board
etc. only!
E nsure that you use even contact pressure. This
will increase sanding sheet life.

Before use

Removing / charging / inserting
the battery pack
buttons and slide the battery pack
8
the unit.
rapid charger .
16
status LED will light up red.
17
charging process has been completed and the
battery pack is ready for use.
9
9
press the release
9
out of
9
into the
9
indicates the
18
into the unit.