Connection To The Audio System; Mains Connection - MC Crypt CDMPX-20 Notice D'emploi

8. Connection to the audio system

The CD player has Cinch sockets LINE OUT (22) for connection to your audio system (e.g. mixing desk).
For connecting the outputs, use only shielded cables. The use of other cables might cause
interferences.
To avoid distortion or mismatching that could damage the device, only devices with the same
connections may be connected to the various connections.
For this, observe also the connection data in the section "Technical Data".
• Connect the sockets LINE OUT (22) with the CD inputs of your mixing desk or pre-amplifier.
• Connect the white socket with the left input and the red socket with the right input.

9. Mains connection

The mains outlets to which the CD player is connected must be easily accessible to quickly
separate the device from the mains voltage in case of an error.
The CD player and all connected devices must be turned off when connecting the voltage
supply.
Ensure that all the electrical connections and connection cables between the different devices
and any extension cables comply with the regulations and the operating instructions.
• Connect the small device connection plug of the power line to the mains connection AC IN (23) on the device.
• Plug the power plug of the power supply cable into a wall socket.
• With the mains switch (24), the CD player is turned on or off (if the side with the dot is pressed, the device is turned
on).
All manuals and user guides at all-guides.com
35