Maytag PDB4600AWE Guide De L'utilisateur page 9

To Change the Door Panel Insert
(select models)
WARNING: Disconnect electrical power to the dish-
washer before changing the door panel insert.
1. Using a Phillips screw driver, remove either the right or
left-hand door trim strips by removing the three screws.
2. Grasp the panel insert(s) and gently flex out slightly. Slide
panel(s) out about two inches. Continue to flex insert
panel(s) enough to remove them. Use care, edges may be
sharp.
All manuals and user guides at all-guides.com
3. Select color and reinstall panel(s). Place insert panel(s)
(notched corners at the top) on the inside of the lower
door panel trim. Make sure the upper notched corners of
the insert(s) are under the control panel.
4. Reinstall the side trim.
8