Before You Call - Maytag PDB4600AWE Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before You Call

Check these points to help save you time and money.
Dishwasher Will Not Fill:
• Be sure door is latched securely.
• Be sure the water is turned on.
• Check that the dial/pad is properly selected for a cycle.
• Allow time for select models to drain/pause before filling.
• Check your home's circuit breaker or fuse box.
• Check inlet hose for a kink.
• Check water valve inlet for sediment and clean if necessary.
Dishwasher Will Not Drain/Water In Tub Bottom:
• If connected to a food waste disposer, be sure the knock-out is removed from the disposer inlet.
• Be sure the drain hose is elevated at least 32" so water cannot siphon back into the tub.
• Check for food obstruction in the drain or disposer.
• Check drain hose for a kink.
• Check your home's circuit breaker or fuse box.
• Check that the cycle is completed.
Detergent Cup Is Not Empty:
• Check that the cycle is completed.
• Be sure dispenser is not blocked by a dish or utensil.
• Use fresh detergent stored in a cool, dry place.
Dishwasher Seems Noisy:
• A water valve hiss during fill is normal.
• Water circulation sounds are normal.
• A ticking noise is a normal timer sound.
• A thumping sound may be a wash arm bumping an item that is extending beyond the racks.
• Chopping or grinding sounds may be heard during drain as the internal food disposer chops hard items like fruit
seeds, nuts, etc.
• Humming during the drain is normal.
• A snap noise is the detergent cup lid hitting the door liner when the dishwasher door is opened at the end of the
cycle. This is normal.
• Proper installation affects the noise level.
Cycle Takes Too Long (Heating Delay Light Stays On, select models):
• AccuTemp
or Temp Boost (select models) has been selected and the cycle is extended if the water temperature is low.
• Check to see that the incoming water temperature is 120-140° F (49-60° C).
Dishwasher has an Odor:
• Run dishes being held in the dishwasher through a Rinse Only cycle.
• Many dishwashers have a "new" smell when first installed. This will dissipate with use.
• Dishwasher may not be draining properly. (See "Won't Drain" section.)
• For a strong odor place baking soda in both sides of the detergent cup. Select Light Wash and allow the water to
circulate for about 10 minutes. Interrupt the cycle by unlatching the door and let it stand overnight. Restart the
dishwasher by latching the door and allow it to complete the cycle. A commercial dishwasher cleaning product such
as Jet-Dry Dishwasher Cleaner* can also be used.
Dishwasher Leaks:
• Check that the dishwasher is level. (Refer to the Installation Instructions.)
• Suds can cause the dishwasher to overflow. Measure the detergent carefully and use only detergents designed for
use in a dishwasher. Less detergent is needed in soft water. Try another brand if sudsing continues.
• Follow directions closely on how to add a forgotten item (pg. 3).
• Be sure the Rinse Aid (select models) lid is securely attached and not leaking.
* Brand names are trademarks of the respective manufacturer.
All manuals and user guides at all-guides.com
Continued on next page.
6

Publicité

Table des Matières
loading

Table des Matières