Fuel Safety; Trimmer/Brushcutter Operating Safety - Maruyama B42L Manuel Du Propriétaire/De L'utilisateur

5. Make sure the debris shield is installed and
positioned correctly before using the Trimmer/
Brushcutter.
6. Never use a cutting head or replacement parts that
are not approved by Maruyama.
7. Maintain the Trimmer/Brushcutter according
to the recommended maintenance intervals and
procedures in the Maintenance section on page
US-23.
8. Shut off the engine and be certain the cutting head
has completely stopped rotating before inverting
the Trimmer/Brushcutter, performing maintenance
on or working on the machine.
9. If running problems or excessive vibration occur,
stop immediately and inspect the unit for the
cause. If the cause cannot be determined or is
beyond your ability to correct, return the Trimmer/
Brushcutter to your servicing dealer for repair.

Fuel Safety

1. Gasoline is highly flammable and must be handled
and stored carefully. Use a container approved for
fuel to store gasoline and/or fuel/oil mixture.
2. Mix and pour fuel outdoors, where there are no
sparks or flames.
3. Do not smoke near fuel or Trimmer/Brushcutter,
or while using the Trimmer/Brushcutter.
4. Do not overfill the fuel tank. Stop filling 1/4-1/2
inch (6 mm-13 mm) from the top of the tank.
5. Wipe up any spilled fuel before starting the
engine.
All manuals and user guides at all-guides.com
— US-8 —
6. Move the Trimmer/Brushcutter at least 10 feet (3
m) away from the fueling location before starting
the engine.
10 feet (3 m) Minimum
7. Do not remove the fuel tank cap while the engine
is running, or right after stopping the engine.
8. Allow the engine to cool before refueling.
9. Drain the tank and run the engine dry before stor-
ing the unit.
10. Store fuel and Trimmer/Brushcutter away from
open flame, sparks and excessive heat. Make sure
fuel vapors cannot reach sparks or open flames
from water heaters, furnaces, electric motors, etc.
Trimmer/Brushcutter Operating
Safety
1. THIS TRIMMER BRUSHCUTTER CAN
CAUSE SERIOUS INJURIES. Read the instruc-
tions carefully. Be familiar with all controls and
the proper use of the Trimmer/Brushcutter.
2. Make sure the φ35mm pin has been removed
from the gearcase and boss adapter before you
start the engine.