Starting And Stopping; Before Starting The Engine - Maruyama B42L Manuel Du Propriétaire/De L'utilisateur

9. Fill the tank only to within 1/4-1/2 inch (6 mm-13
mm) from the top of the tank. Avoid filling to the
top of the tank filler neck.

Starting and Stopping

Before Starting the Engine

1. Fill the fuel tank as instructed in the Before
Operation section of this manual. (page15)
2. Rest the Trimmer/Brushcutter on the ground.
3. Make sure the cutting attachment is clear of any
broken glass, nails, wire, rocks or other debris.
4. Keep all bystanders, children and animals away
from the working area.
Fuel Return Line
Cold Starting Procedure
The carburetor on this engine is equipped with a fuel
primer and a choke system. To start a "cold" engine
properly, perform the following procedure:
1. Pump the primer bulb until fuel can be seen flow-
ing through the fuel return line to the fuel tank.
(Flowing fuel should be almost clear, not foamy or
full of bubbles.)
2. Turn the choke lever to the Close position.
3. With the stop switch "ON", and the throttle trig-
ger positioned at Fast-idle position, pull the starter
grip.
All manuals and user guides at all-guides.com
Primer Bulb
— US-18 —
Choke Lever
Fast-idle Start Lock
START (ON)
STOP (OFF)
Stop Switch
CAUTION
• Do not pull the Starter rope all the way
out .
WARNING
• Do not disassemble the Starter.
P l e a s e a s k f o r
MARUYAMA ser vice dealer.
After the engine is started, turn the choke lever to the
Open position. Then squeeze and release the throttle
trigger to allow it to return to the idle position.
If the engine stops running before you turn the choke
lever to the open position:
Go ahead and open the choke, pull the starter grip with
the throttle trigger positioned at Fast-idle position.
Starter Grip
Fast-idle Position
Idle Position
a n a u t h o r i z e d