Fuel Safety; Power Edger Operating Safety - Maruyama E23 Manuel Du Propriétaire/De L'utilisateur

9. If running problems or excessive vibration occur,
stop immediately and inspect the unit for the
cause. If the cause cannot be determined or is
beyond your ability to correct, return the Edger to
your servicing dealer for repair.

Fuel Safety

1. Gasoline is highly flammable and must be handled
and stored carefully. Use a container approved for
fuel to store gasoline and/or fuel/oil mixture.
2. Mix and pour fuel outdoors, where there are no
sparks or flames.
3. Do not smoke near fuel or Edger, or while using
the Edger.
4. Do not overfill the fuel tank. Stop filling 1/4-1/2
inch (6 mm-13 mm) from the top of the tank.
5. Wipe up any spilled fuel before starting the
engine.
6. Move the Edger at least 10 feet (3 m) away from
the fueling location before starting the engine.
10 feet (3 m) Minimum
7. Do not remove the fuel tank cap while the engine
is running, or right after stopping the engine.
8. Allow the engine to cool before refueling.
9. Drain the tank and run the engine dry before stor-
ing the unit.
10. Store fuel and Edger away from open flame,
sparks and excessive heat. Make sure fuel vapors
cannot reach sparks or open flames from water
heaters, furnaces, electric motors, etc.

Power Edger Operating Safety

1. THIS EDGER CAN CAUSE SERIOUS
INJURIES. Read the instructions carefully. Be
familiar with all controls and the proper use of the
Edger.
2. Make sure the 3 mm hex wrench has been
removed from the gearcase and boss adapter
before you start the engine.
3. Avoid using the Edger near rocks, gravel, stones
and similar material which can become dengerous
projectiles.
4. Keep children, bystanders and animals outside a
50 ft. (15 m) radius from the operator and Edger.
50 ft. (15 m Minimum)
5. If you are approached while operating the Edger,
stop the engine and Edger blade rotation.6. Never
allow children to operate the Edger.
— US-9 —