Replacing An Oven Light; Replacing The Control Knob Led - Furrion FS17WB4A-BL Manuel D'instructions

Fig. 25
Fig. 26
6. Place the door on a flat surface that is protected so the
door does not damage the material of the surface.

Replacing an Oven Light

1. Disconnect the oven from the power supply by means of
the switch used to connect the appliance to the electrical
mains, or unplug the appliance if the plug is accessible.
2. Remove the glass cover of the lamp-holder. (Fig. 27)
Fig. 27
3. Remove the lamp and replace with a lamp resistant to high
temperatures (572 o F) with the following characteristics:
- Voltage: 12V
- Wattage: 15 W
- Type: G9
- Lamp Type: Halogen
4. Replace the glass cover.
5. Reconnect the power to the oven.
16
To reorder the Furrion oven light bulb replacement, please
call Furrion service for assistance.

Replacing the Control Knob LED

1. Disconnect the oven from the power supply by means of
the switch used to connect the appliance to the electrical
mains, or unplug the appliance if the plug is accessible.
2. Grasp and pull on the control knob with the broken LED
light. (Fig. 28)
Fig. 28
3. Remove the two screws holding the LED light using a
Phillips screwdriver. (Fig. 29)
Fig. 29
4. Remove the LED assembly and disconnect the wire from
the base of the LED assembly. (Fig. 30)
Fig. 30