SilverCrest SHLF 2000 D1 Instructions D'utilisation page 27

Risk of damage of the
product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (–) on the
battery / rechargeable battery
and the product.
Clean the contacts on the
battery / rechargeable battery
and in the battery compartment
before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
˜ Before first use
Remove the packing materials.
Check the product for any damages.
Pull the insulating strip from the battery
compartment 21.
NOTE: The product may give off some vapours
or odours during first use. These are production
or transport residue that will quickly subside.
There may also be quiet noises such as clicking
or crackling. These will also quickly subside
once the plastic parts have finally adjusted to the
operating conditions.
˜ Operation
NOTES:
The product is equipped with a tilt protection
switch 13 at the bottom of the product. The
product shuts down automatically if it falls over or
if it is lying on its side.
All manuals and user guides at all-guides.com
The product cannot be turned on if it is not
standing securely and the tilt protection switch 13
is not pressed.
˜ Turning on the product
Connect the power plug 19 to a suitable power
outlet.
Activating the standby mode: Set the on/off
switch 18 to I. A short beep sounds. The display
6 shows the room temperature 25. 0:00
flashes.
Turning on the product: Press
switches to fan mode.
NOTE: When the product is in operation, the
control lamp 11 is lit.
˜ Turning off the product
Switching to standby mode: Press
NOTE: The fan continues to run for about
another 2 seconds. Afterwards, the product turns
off and the control lamp 11 goes out.
Turning off the product fully: Set the on/off switch
18 to 0.
˜ Control panel
Press the buttons on the control panel 1 or use
the remote control 20 to make settings:
NOTE: In standby mode, no settings can be
made. First, switch on the product by pressing
8 .
Button Setting
Timer
3
Swivel function
4
Operating mode
5
Increase value
7
Standby/operation
8
Decrease value
9
8 . The product
8 .
GB/IE 27