R&G LP0247BK Instructions De Montage page 11

•
Carefully ease the left-hand side seat infill panel away from the frame and remove the push
rivet arrowed in picture 14.
•
Carefully remove the infill panel as shown in picture 15.
•
Remove the two hex headed bolts arrowed in picture 16 and remove the left-hand side grab
rail.
•
Page | 11
Remove the two hex headed bolts arrowed in picture 17 and remove the right-hand side grab
rail.
•
Remove the two push rivets arrowed in picture 18.
•
Remove the two bolts arrowed in pictures 19 and 20.
•
Carefully remove the two seat cowls as shown in pictures 21 and 22.
•
Remove the two bolts arrowed in pictures 23 and 24.
•
Remove the four bolts arrowed in picture 25 while supporting the original licence plate
bracket from below.
•
Slide the rubber plug socket cover along the wiring loom to give access to the indicator and
licence plate illuminator as indicated in picture 26.
•
Disconnect the three wiring plug sockets arrowed in picture 26.
•
Gently lower the original licence plate bracket and remove the two screws arrowed in picture
27.
If reusing the original indicators
•
Remove the four screws arrowed in picture 28.
•
Remove the plastic wiring cover/splash guard to allow access to the indicators.
•
Remove the indicator clamp screw arrowed in picture 29
•
Remove the indicator clamp bracket as arrowed in picture 30.
•
Remove the indicator spreader plate as arrowed in picture 31.
•
Gently squeeze the indicator stem and remove the indicator as shown in picture 32
•
Repeat the above steps to remove the opposite indicator.
•
Fit the indicators into the new licence plate bracket (item 14) and secure as shown in pictures
33, 34, 35 and 36.
If using the mini indicators
•
To fit the R&G Mini Indicators (R&G mini indicator product code RG371 for LED type
or RG372 for Aero Style led type).
•
Position the two indicator adaptors (item 9 –I0039) onto the wiring of each indicator,
ensuring the sides facing each other have the raised centre profile, before fitting the
flanged nut supplied, as shown in pictures 37 and 38.
•
Feed the indicator wiring through the nut/wire cover (item 8) as shown in pictures 39 and
41 (it helps if a small amount of liquid detergent is used) and position the nut cover over
the nut.
•
Fit one length of smaller heat-shrink (item 12) to the wires of each indicator so it goes
over the tail of the nut/wire covers.
•
Fit the R&G licence plate illuminator (item 10) as shown in pictures 40 and 41, please
note you will have to fit the light shroud and use a small amount of adhesive to hold it in
position. Fit one length of the smaller heat-shrink (item 12) to the wire.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email:
11
LP0247
info@rg-racing.com