weewell WMA420 Mode D'emploi page 15

All manuals and user guides at all-guides.com
The parent unit does not play any sound when there is noise from the baby unit.
• Make sure the parent unit is powered up by connecting it to mains power or to the
rechargeable batteries provided.
• Make sure the parent unit is turned on and the speaker volume is not set to off.
• The parent unit may be too far away from the baby unit. Move the parent unit closer
to the baby unit (but not less than 1.5 metres).
• If the parent unit is powered by the provided batteries, make sure there is sufficient
charge. Charge the battery in the parent unit for up to 12 hours.
• Large obstructions may impact the reception. Try to relocate the baby unit, away
from large obstructions such as walls and doors.
• Remove the batteries and then install it again. Turn on the baby unit and the parent
unit. Allow up to one minute for the parent unit and the baby unit to synchronise.
• Other electronic products may cause interference with your audio monitor. Try
installing your audio monitor as far away from these electronic devices as possible:
wireless routers, radios, cellular telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and cordless telephones.
Battery low at the Parent Unit.
• Charge the battery in the parent unit for up to 12 hours.
• The volume level of the parent unit may be set too high which consumes power.
Decrease the volume level of the parent unit. Refer to Adjust speaker volume (p. 15)
for volume level settings.
• Remove the battery and then install it again. Use it until fully depleted, then
recharge it in the parent unit for up to 12 hours.
• If the above measures do not correct the problem, replace the battery.
The battery does not charge in the parent unit or the parent unit battery does
not accept charge.
• Make sure the batteries are installed in the parent unit battery compartment
correctly. The Charging indicator light on the parent unit should be on when
charging.
• Remove the battery and then install it again, then charge for up to 12 hours.
• If the battery is completely depleted, it may take up to 30 minutes to charge the
parent unit before it can be used for a short time.
• Purchase new batteries. Refer to Parent unit battery installation and Parent unit
battery charging.
The parent unit beeps.
• Move the parent unit closer to the baby units (but not less than 1.5 metres). The
parent unit may be out of range.
• The batteries may be running low, Connect the parent unit to the mains power with
the supplied power adaptor for recharging.
• The baby unit may be switched off. Press and hold
key to switch on the baby unit.
I 15
WMA420 USER MANUAL