Beninca BULL 1524 Mode D'emploi page 26

The rapid closure is enabled or disabled
On: rapid closure is enabled. When the gate is open or moving, the photocell activation causes
SCL
the automatic closure of the gate after 3 s. It is activated only with TCA:ON
Off: rapid closure is disabled.
Selects the operating mode of the "Step by step button" and of the transmitter.
PP
On: Operation: OPEN > CLOSE > OPEN >
Off: Operation: OPEN > STOP > CLOSE > STOP >
Enables or disables pre-blinking.
PRE
On: Pre-blinking enabled. Blinking is activated 3s before the motor starts.
Off: Pre-blinking disabled.
Enabled or disables HOLD-TO-RUN function
On: HOLD-TO-RUN function.
htr
The pressure of the OPENS/CLOSES button must be maintained throughout the entire manoeuvre.
The opening of the STOP input stops the motor. All the safety inputs are deactivated.
Off: Automatic/semiautomatic function
Enables or disables the cloned ARC transmitters.
On: The transmitters of the AK series cloned from an already memorized ARC transmitter are
cvar
enabled.
Off: Cloned transmitters are not enabled.
Selects the operating mode of the blinking light during the time TCA
ltca
On: Blinking light on during TCA
Off: Blinking light off during TCA
Enables OPEN input as Pedestrian input (Partial parameter TPED opening).
oppd
On: OPEN input enabled as pedestrian input (PED).
Off: No modification to the OPEN input
Enables or disables checking of photocells on PHOT input, active both in closing and in opening.
On: Check enabled. If the check has a negative result, no manoeuvre is commanded. See Fig.23
TST1
- "PHOTO TEST". (AUX1=3)
Off: Check of photocells each time a manoeuvre is disabled. This setting requires maintenance
of photocells every 6 months.
Enables or disables the check of photocells on PHOT C input.
On: Check enabled. If the check fails, no manoeuvre will be enabled. (AUX1=3)
tst2
Off: Check of photocells each time a manoeuvre is disabled. This setting requires maintenance
of photocells every 6 months.
Enables or disables the TEST of the COSTA (BAR) input.
The activation of the TEST function is possible only with the use of the articles SC.RF and RF/
RF.SUN, consult the specific instructions.
tst3
On: Test enabled. If the test has a negative result, no operation is commanded. See Fig.2 -
"BAR TEST".
Off: Checking disabled.
The "forced opening in case of power cut-off" function is activated or deactivated (it can be
activated only with connected and operating emergency batteries).
On: Activated function. In the event of power failure, before the emergency battery completely
aopf
discharged, the control unit causes an opening operation.
The door remains open until the power supply is back.
Off: Deactivated function.
The opening direction of the motor is selected:
minv
On: Right side motor mount
Off: Left side motor mount (fig.20)
Enables or disables remote radiotransmitters learning, as indicated in the paragraph "Remote
transmitters learning".
rem
On: Remote learning enabled.
Off: Remote learning not enabled.
Enables or disables the energy saving feature "ESA".
On: once the opening or closing manoeuvre is completed, the control unit goes into the
maximum energy efficiency condition, reducing absorption to a minimum, disconnecting the
power transformer and the accessory outputs.
Note: the ESA function is not activated if:
esa
- the battery charger board is being recharged
- the AUX1 or AUX 2 logic is set to 0 and the door is open.
- during the service light activation time if AUX1 or AUX 2:2.
Off: Energy saving disabled. To be used if you wish to have the accessory power output
always on, for example when using keyboards powered at 24 Vdc, or other devices that need
to be powered at all times.
MENU
By selecting this function, the receiver goes in waiting (Push) for a transmitter code to assign to the step-step function.
Press the key of the transmitter to assign to this function.
PP
If the code is valid, it is memorised and the message OK is displayed
If the code is not valid, the message Err is displayed
26
8.4.3) RADIO (RADI)
FUNZIONE
(OFF)
(OFF)
(OFF)
(OFF)
(ON)
(OFF)
(OFF)
(OFF)
(OFF)
(OFF)
(OFF)
(OFF)
(ON)
(ON)