Midland Alan 48 Excel Multi Mode D'emploi page 5

5. "AM/FM" Indicator
It.indicates.the.operative.mode..FM:.red.LED;.AM:.green.LED..
. "RX/TX" Indicator
LED.indicating.receiving.or.trasmitting.mode..RX:.green.LED;.TX:.red.LED.
7. "CB/PA" Selector
In.the."CB".position,.the.unit.operates.as.a.transceiver..You.can.use.the.PA.(public.
address).function.only.if.you.connect.a.speaker.to.the.PA.jack.("PA".visualized.on.
the display). In this case the "MIC" knob controls the amplification level.
8. FUNC button
With.the.SCAN.button,.you.can:
• visualize. the. operative. frequency. (if. you. keep. pressing. the. button. for. 3. seconds
approx.), or the channel in use;
• activate the second functions of the "M" (M1/M5) buttons.
M1 / M2 / M3 / M4 / M5:
ALAN 48 EXCEL has the possibility to store and to recall, when necessary, 5
channels previously memorized.
To memorize one channel, follow the procedure herebelow:
A) Select the channel with the appropriate selector or the "UP/DN" buttons on the
microphone;
B) Push the "FUNC" button: the display will show "F";
C) Keep pressing the "M1/EMG" button for 3 seconds: you will hear a "BIP" and the
display will show "M1".
To memorize the other preset, repeat these steps and select another memory
different from 1.
To recall a channel previously stored, push the "FUNC" switch and the button of the
desired memory.
These buttons have two functions; herebelow you will find their descriptions:
9. "M1 - EMG" switch
This switch allows the storing of the first memory and the recalling of the 2 emergency
channels.."M.-.EMG".selects.sequentially.channels.9./.9.(emergency).and.the.one
in.use.
0.."M2 - DW" button
"M2.-.DW".stores.the.chosen.channel.in.the.M2.memory.and.activates.the.DUAL
WATCH.. This. function. allows. the. synthonization. on. two. different. channels. at. the
same.time:
when a signal on the second channel is received, the conversation on the first one
is.automatically.interrupted.and.the.receiver.switches.on.the.second.channel..The
monitoring starts again 5 seconds after the signal end.
To.activate.this.function,.operate.as.follows:
- Select the desired channel through the channel selector or the "UP/DOWN"
buttons.on.the.microphone;
- Keep the "DW" button pressed for about 3 seconds: you will hear a "BIP" and
"DW" will flash on the display.
-.. Select.the.second.channel.with.the.same.procedure;
-.. Press.the.button."DW".again.for.roughly.3.seconds:.you.will.hear.another."BIP";.
the.display.will.permanently.show."DW".and.will.alternatively.visualize.the.two.
selected.channels.
.."M3 - SCAN" switch
The.two.functions.of.this.button.are:.memorization.of.the.third.channel.in.the.M3.
4 4