HQ Power VDPC146 Mode D'emploi page 6

5. Operating Instructions
A) Programming
1) Leaving the Recording Mode
• Hold the RECORD button.
• Press the REC EXIT button.
• Release the RECORD button.
The red LED indicator above the RECORD key is now dimmed, meaning that the programming mode has been
deactivated and cannot be accessed.
2) Activating the Recording M
• Hold the RECORD button.
• Press the following flash keys in PRESET A : 1-5-6-8
• Release the RECORD button.
The red LED indicator above the RECORD key is now lit, meaning that the programming mode has been activated
and can be accessed.
3) Erasing all Programmes
• Hold the RECORD button.
• Press the following flash keys in PRESET A : 1-3-2-3.
• Release the RECORD button.
4) Clearing the Memory
• Hold the RECORD button.
• Press the REC CLEAR button.
• Release both buttons.
5) Recording a Scene
• Press MODE SELECT to select the 1-24 SINGLE / PRESET PARK function. The green LED indicator lights up.
• Select the desired page with the PAGE button
• Slide both master faders to the top position (MASTER A = 10 & MASTER B = 0)
• Place the 24 channel sliders in the desired position.
• Press the RECORD button to store the scene in the memory.
• Slide both master faders to the lowest position (MASTER A = 0 & MASTER B = 10).
• Hold the record button
• Press the flash button of your choice (13-24)
• Release the RECORD button.
The scene is now stored under one of the keys of n°7 in fig. 1 on page 2
6) Deleting a Scene
• Select the desired page with the PAGE button
• Hold the RECORD button.
• Press the flash button (13 – 24) where the scene was stored twice
• Release the RECORD button
VDPC146
All manuals and user guides at all-guides.com
6 VELLEMAN