Breville the Milk Cafe BMF600XL Livret D'instructions page 14

OPERATING yOUR BREvILLE MILK CAFé™
7. Press the center of the START | STOP
push-dial to commence frothing. The
button surround will flash throughout
the duration of the frothing cycle. There
will be no movement inside the milk jug
for a few seconds due to the soft start
delay, then milk will slowly start to swirl.
NOTE
Do not remove the jug lid from the milk
jug, or the milk jug from the power
base during operation.
To stop operation at any time, press the
center of the START | STOP push-dial.
Operation has stopped once the button
surround has stopped flashing.
WARNING
Appliance surfaces will be hot during
and after operation.
8. When the milk has reached the selected
temperature, the milk frother will
automatically stop and the 'ready' alert
will sound. This will take anywhere
between 2 -7 minutes depending on the
quantity of milk used. Carefully remove
the milk jug from the power base as
the milk jug and contents will be hot.
Be careful not to place the milk jug on
a table cloth, plastic surface or heat
sensitive surface which may scorch or
melt. Remove the jug lid, pour and/or
spoon out the frothed milk.
9. Clean the milk jug and frothing disc
immediately after use. Both will be hot,
so follow the instructions on page 17 and
allow them to cool completely before
disassembling.
NOTE
When frothing multiple batches,
to prevent the Boil Dry Protection
from activating (see page 14), we
recommend allowing the milk jug
to cool for approximately 5 minutes,
or filling the milk jug with water for
faster cooling. For best results, we
also recommend cleaning the milk
jug and frothing disc before re-use.
NOTE
After frothing the first batch of
milk you may notice the power base
begin to hum. This is normal. It
is the cooling fan preventing the
milk frother from overheating and
will automatically cease to hum
once adequately cooled. During
this time, you may still use the milk
frother unless the Boil Dry Overheat
Protection as been activated
(see page 14).
USING THE 'COLD STIR' SETTING
The 'Cold Stir' setting allows you to
stir already cold or hot milk without
additional heat.
Use it to froth milk for cold beverages
such as an iced cappuccino; to blend in
syrups and flavorings for an iced chocolate
or mocha; or to stir in dissolvable instant
drinking powders into milk or water.
The 'Cold Stir' setting will operate for 60
seconds before automatically stopping. You
can re-select the 'Cold Stir' setting if desired.
13