Funkwerk elmeg CS290 Notice D'utilisation page 10

English
elmeg IP-S290 at the Ethernet-port
Figure 3
Audio in / Audio out
The telephone is equipped with an input (7) and an output (8) for audio signals. These ports are provided
for headsets. The jacks are linked to the corresponding ports for the headset jacks on the bottom of the tele-
phones.
Connecting to and operating the system telephone at the pabx system (basic function including
DHCP)
Consult the installation instructions for the PABX system to determine which port can be used for connec-
ting the IP-S290. Connect this port with the Ethernet PABX port on the system telephone.
• Configure your PABX system for use with IP system telephones.
• Define the MSNs for the IP system telephones within the PABX system.
• Switch on the power (plug-in power supply unit) to the IP system telephone and wait until the tele-
phone has been initialized.
Once the IP system telephone has been initialized you will be requested to select the language in the display.
• Select the display language.
Press the arrow buttons to view the available
languages and confirm your selection by pres-
O
sing .
• Enter one of the MSNs that has been input to the PABX system (in the example shown here, 12) .
Confirm your entry by pressing
Swtich to Use DHCP.
Select » « .
on
• The telephone and PABX system are synchronized.
6
All manuals and user guides at all-guides.com
O
.
-
1 Connection for plug-in power
supply unit
-
2 Plug-in power supply unit
-
3
Ethernet PC-Connection
-
4 PC or other IP-telephone
-
5
Ethernet-port of the pabx
-
6 elmeg pbx
-
7
Audio-In connection (micropho-
ne)
-
8 Audio-Out connection (hand-
set)
-
9 Headset with two 5mm-ste-
reo-connectors.
Welche Sprache
deutsch english polski
Program dial number
MSN-1>12
use DHCP
off on