shark Infinity NR90C Manuel D'utilisation page 11

12. Replace the rush roll cover over the agitator. (Fig. 44)
13. Replace the headlight assembly onto the brush roll cover.
(Fig. 45)
14. Replace the power nozzle cover back onto the unit. Be careful
not to catch any loose wires in the slots when pushing in the
cover.
15. Turn the power nozzle over and replace the six (6) screws.
Changing the Headlight
WARNING:
To reduce the risk of electric shock, the power cord
must be disconnected before performing any maintenance/trouble
shooting checks.
Occasionally, the headlight will need changing. To change the
headlight:
1. Turn the power nozzle On/Off button to the "Off" position.
2. Turn the vacuum off and disconnect the power cord from the
electrical outlet.
3. Disconnect the power nozzle from the telescopic tube.
4. Turn the power nozzle upside down and using a #1 Phillips
screw driver, remove the six (6) screws from the bottom plate.
(Fig. 36)
5. Turn the power nozzle over and remove the power nozzle
cover. (Fig. 37)
6. Hold the light bulb securely in your hand and pull it out.
7. Hold the new bulb and push it in to replace it.
8. Replace the power nozzle cover.
9. Turn the power nozzle over and replace the six (6) screws.
MAINTENANCE INSTRUCTIONS
Fig. 44
Fig. 45
Motor Thermostat
Important: This unit is equipped with a motor protective
thermostat. If for some reason the vacuum cleaner should
overheat, the thermostat will automatically turn the unit off.
Should this occur:
• Push the On/Off button once.
• Disconnect the plug from the power source.
• Check the source of overheating problem. (i.e. clogged
hose or filter)
• If clogged hose or filter is found, unclog the hose and
clean the filters.
• Wait at least 45 minutes before attempting to reuse the
vacuum.
• After unit has cooled down for 45 minutes, plug in the
cleaner and push the On/Off button. The vacuum should
start again.
• If the vacuum still does not start, contact customer
service at 1 (888) 668-9600.
10