Valor Madrona MFCS05 Manuel D'installation page 7

27. Connect the gas supply pipe to the gas valve as
shown below. Note that the pipe travels below the
pipe bracket attached to the stove left side.
Pipe bracket
Front view
28. Secure the gas pipe with the clamp and screw
provided with the engine's hardware pack.
Pipe bracket
Pipe clamp
Front view
29. Connect the gas supply and install venting system.
30. Install the inlay panels at the bottom of each side
panel. The bottom is held in place by magnets.
Secure the top rear of the inlay with a screw.
Optional fan (if installed)
Lower bracket
(transparent for clarity)
Lower bracket
(transparent for clarity)
Detail—viewed
from underside
31. Place the access door and secure it as well as the
front of the inlay panel to the assembly with two
washers and a screw. Do not tighten the screw all
the way to allow access door rotation.
The access door opens and closes hinging on the
screw at each end.
To close the door, rotate it upward and push it
straight away from you. When closed, the tab at
each end of the door goes underneath the lower
support bracket to hold it from falling open.
To open de door, pull it straight towards you then
rotate it downward.
Tab goes under
lower bracket
lower bracket
7