Transportation, Storage And Disposal - Husqvarna PG 830S Manuel D'utilisation

Problem
There are sudden un-
wanted movements
in the product.
The internal circuit
breaker releases.
Transportation
WARNING: Be careful during transportation.
The product is heavy and can cause injury
or damage if it falls or moves during
transportation.
The wheels let you move the product shorter distances.
For longer distances, lift the product to move it or put the
product on a vehicle.
CAUTION: Do not tow the product behind a
vehicle.
• Be very careful when you move the product
manually or on surfaces with a slope. Small slopes
can result in a fast movement that is not possible to
brake by hand.
• Safety the product during transportation. Make sure
that it cannot move.
• Put some type of protection on the product during
transportation. The protection keeps natural
elements such as rain and snow away from the
product.
• Always use the lifting eye on the product when you
lift the product.
• Do not lift the product by the handlebar, motor,
chassis or other parts.
• Transportation is best done on a pallet.
• Always lift the product with a lift or forklift.
• Do not use a forklift if the product is not put on a
pallet or carriage. This can cause damage to the
grinding discs and other internal components.
• During transportation, the grinding head must be on
the ground. To prevent damage to the lock
22
Cause
The grinding discs are worn or damaged.
The diamond tools are incorrectly attached or
attached at different heights on the grinding
discs.
The head locks are loose or missing.
Too high a load or not sufficient power sup-
ply.

Transportation, storage and disposal

Solution
Examine the grinding discs for damaged
parts and too much movement.
Make sure that all diamond tools are installed
correctly and that all have the same height.
Make sure that all head locks are in position
and tightened.
Do a check of the power supply.
Decrease the grinding pressure, increase the
number of diamond tools or increase the
bond hardness.
mechanism of the tool plates, keep the tool plates
installed.
To set the product in transport position
• Fold down the handle. Refer to
and the handlebar on page 13 .
• If the weights are attached to the product, adjust the
weights to forward position. Refer to
weights on page 17 .
• Make sure that the grinding head touches the
surface.
To move the product up and down a
ramp
WARNING: Be very careful when you move
the product up and down ramps with the
motor on. The product is heavy and there is
a risk of injury if the product falls or moves
too quickly.
WARNING: For ramps with a steep slope,
always use a winch. Do not walk or stay
below the product. Do not stay in the
To adjust the handle
To adjust the
1253 - 003 - 22.01.2020