Husqvarna PG 830S Manuel D'utilisation page 13

WARNING: Make sure that the product
is in a stable position before you replace
the diamond tools.
7. Put on protective gloves.
8. Turn the tool plate (C) to the right or to the left to
unlock the tool plate from the grinding disc.
9. Pull the tool plate straight out (D) to remove the tool
plate from the grinding disc.
10. Use a hammer to remove the diamond tools from the
tool plate.
11. Attach new diamond tools to the tool plate with a soft
hit of the hammer.
12
12. Attach the tool plate straight (E) on the grinding disc.
C
13. Turn the tool plate (F) to the right or to the left to lock
the tool plate to the grinding disc.
14. Carefully lift the product to operation position. Use
the handlebar and the support frame for support.
D
15. Disengage the support frame.
To connect a dust extractor
WARNING: Do not use the dust extractor if
the dust extractor hose is damaged. The risk
increases that you breathe in dust that is
dangerous to your health. Use approved
respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Make sure that the STOP/RUN switch on the control
panel is set to 0.
4. Connect the dust extractor hose to the product.
5. Engage the support frame. Refer to
disengage the support frame on page 10 .
E
F
To engage and
1253 - 003 - 22.01.2020