Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
5.
The inlet hose filter and the valve filter
To clean the water inlet filters:
1.
1
2
3
3.
Troubleshooting
The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer
to the table). If not, contact the service centre.
30
All manuals and user guides at all-guides.com
4.
6.
2.
4.
45°
20°
Frost precautions
If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the
drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Remove the drain hose from the rear
support and unhook it from sink or spigot
5. Put the ends of the drain and inlet hose
in a container. Let the water flow out of
the hoses.
6. When no more water flows, install the in-
let hose and the drain hose again.
Warning! Make sure that the temperature
is more than 0 °C before you use the
appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
www.zanussi.com
Publicité
Chapitres
Table des Matières
