Télécharger Imprimer la page

Protection Mechnisms; Safety Mechanisms; Warranty; Maintenance And Metrological Verification - Metrix MX 22 Notice De Fonctionnement

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
If any faults or abnormalities are observed, take the instrument
out of service and ensure that it cannot be used until it has been
checked out.
It is recommended to remove the battery from the instrument if
not used.
1.2
Protection mechanisms
This instrument is fitted with various mechanisms :
Varistor protection for limiting transients of over 600 V at the VΩ
terminal, particularly 6 kV pulse streams as defined by the French
standard IEEE 587.
A PTC (Positive Temperature Coefficient) resistor protects
against permanent overvoltages of up to 600 V during resistance,
continuity and diode test measurements. This protection is reset
automatically after overload.
Two HBC fuses provide protection up to 600 V during measure-
ments of intensity type.
An IP protection rating of 40.
1.3

Safety mechanisms

The battery and fuse unit cannot be accessed without first
disconnecting the measuring leads.
If the maximum range is repeatedly exceeded, an intermittent
audible signal warns the user in all functions, except in Ω,
and Hz functions.
1.4

Warranty

This equipment is warranted against any defects of manufacture or
materials according to the general conditions of sale.
During the warranty period (1 year), defective parts will be replaced,
the manufacturer reserving the right to repair or replace the product.
In the event of the equipment being returned to the after sale
department or to a local agency, carriage to the centre shall be
payable by the customer. The warranty does not cover the following :
1. Repairs necessitated by misuse of the equipment or use in
association with incompatible equipment.
2. Modification of the equipment or any related software without the
explicit authorization of the manufacturer.
3. Repairs necessitated by attempts to repair or maintain the product
made by a person not approved by the manufacturer.
4. Adaptation to a specific application not provided for in the
specifications of the equipment or the user manual.
5. Damage after a drop, a shock or flooding.

1.5 Maintenance and metrological verification

Return your instrument to your distributor for any work to be done
within or outside the guarantee.
Portable 4000 count digital multimeter
17

Publicité

loading