Operation Instructions - HOLZMANN MASCHINEN D 460FXL Mode D'emploi

13 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
13.1

Operation instructions

Perform all machine settings with the machine being
disconnected from the power supply!
Never switch the machine on while pressing the chisel against the
material!
HOLZMANN MASCHINEN GmbH
W A R N I N G
Before switching the machine on, make sure that the tool rest

is firmly tightened
 Rotate the clamped workpiece each time before turning by
hand to ensure that it runs freely and does not touch the rest
tool!
 Thereby check also whether the workpiece is centred and
tighten clamped!
 Make sure to guide and hold the chisel with both hands safe
and tight during machining!
 Work only with well sharpened tools!
 Work large and unbalanced workpieces at low spindle speed
only!
 Specifications regarding the maximum or minimum size of the
workpiece must be observed!
 Workpieces with cracks may not be used!
 Only process selected woods without defects!
www.holzmann-maschinen.at
A T T E N T I O N
N O T I C E
OPERATION
25
D 460FXL