Intended Use; Security Instructions; Remaining Risk Factors - HOLZMANN MASCHINEN OFT 102 Mode D'emploi

Table de défonceuse
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10
SAFETY

10.1 Intended Use

The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the
assembly instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
Milling wooden workpieces in combination with a router.
The machine shall not be operated outdoors or in wet or damp areas.
Any manipulation of the machine or its parts is a misuse, in this case
MASCHINEN
and its sales partners cannot be made liable for ANY direct or indirect
damage.

10.2 Security instructions

10.3 Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
HOLZMANN MASCHINEN GmbH
Always read the instruction manual of the mounted router!
Keep your work area dry and tidy! An untidy work area may cause
accidents. Avoid slippery floor!
Make sure the work area is lighted sufficiently
Always stay focused when working. Reduce distortion sources in
your working environment. The operation of the machine when
being tired, as well as under the influence of alcohol, drugs or
concentration influencing medicaments is forbidden.
Make sure there is nobody, particularly children, present in the
dangerous area!
Always place the table on a level floor
Provide good stability and keep balance all times!
The base legs should be locked in position and well tightened
before the power tool is installed.
Do not overload the table!
www.holzmann-maschinen.at
WARNING
WARNING
SAFETY
HOLZMANN-
11
OFT 102

Publicité

Table des Matières
loading

Table des Matières