Microwave Oven Control; Display; Progress Bar; Number Codes - KitchenAid YKHMS175M Guide D'utilisation Et D'entretien

MICROWAVE OVEN CONTROL

Display

When power is first supplied to the microwave oven, a ":" will
blink on the display. Touch OFF to stop the blinking. If the ":"
blinks on the display at any other time, a power failure has
occurred. Touch OFF and reset the clock if needed.
If "RETRY" blinks on the display for 1 second, an invalid value
has been entered. Retry your entry.
When the microwave oven is in use, the display shows cooking
power, quantities, weights and/or prompts. When the microwave
oven is not in use, the display shows the time of day or Timer
countdown.

Progress Bar

The progress bar is a visual picture of the estimated running time
of a cooking cycle. It will appear during all cook cycles except
Warm Hold. The lines in each of the segments will light from left
to right as the time nears the end. When all 15 lines (all
3 segments) are lit, the cooking cycle is complete.

Number Codes

The microwave oven is preset with shortcut number codes. A
number code includes one or more of the following: cooking
power, cook time and food quantity or weight. See the charts in
the "Cooking" and/or "Reheating" sections for additional
information.
The START pad begins any function except the Timer. If
nonsensor cooking is interrupted, touching START will resume
the preset cycle.

Add a Minute

Cook time may be added in 1-minute increments, up to
99 minutes, by touching ADD A MINUTE.
Touching ADD A MINUTE during a cook cycle will add 1 minute
of cook time at the current cook power.
Touching ADD A MINUTE when the microwave oven is not in use,
or after a cook cycle has ended, will start the microwave oven for
1 minute of cook time at 100% cook power.
The OFF pad clears any incorrect command and cancels most
functions except for the Timer, Child Lock and Demo Mode. It will
not erase the time of day.
The oven will also turn off when the door is opened. Close the
door and press START to resume the cycle. A sensor cooking
cycle may not be resumed if interrupted by opening the door.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
The microwave oven and Timer must be off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK or START.
To Remove:
1. Touch CLOCK.
2. Touch 0.
3. Touch CLOCK.
The time will disappear and ":" will appear on the display.

Start

Off

Clock

7