Indoor Installation; Outdoor Installation - Bestway SALUSPA MIAMI AIRJET Manuel De L'utilisateur

3. Affix the warning label.
To order the warning label, please contact your local Bestway After Sales Service.
IMPORTANT:
is smooth, flat, level and capable of supporting the weight for the entire time the
SaluSpa is installed (not on the carpet or other similar material). If the SaluSpa is
placed on a surface which does not meet these requirements, any damage caused
by improper support is not covered under the manufacturer's warranty. It is the
responsibility of the SaluSpa owner to assure the integrity of the surface at all times.

1. Indoor Installation:

Be aware of special requirements if you install the spa indoors.
• Humidity is a natural side effect with SaluSpa installation. First determine the
effects of moisture on exposed wood, paper, etc. in the proposed location. To
minimize these effects, it is best to provide plenty of ventilation to the selected
area. An architect can help determine if more ventilation is needed.

2. Outdoor Installation:

• During filling, draining or when in use, water may spill out of the spa. Therefore the
SaluSpa should be installed near a floor drain.
• Do not leave the spa surface exposed to direct sunlight for long periods of time.
IMPORTANT: RISK OF ELECTRIC SHOCK. THE GFCI MUST BE TESTED
BEFORE TURNING ON THE PUMP EACH TIME.
WARNING: The GFCI plug must be tested before each use to avoid risk of electric
shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of
the power outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails. For assistance, please visit the
support section on our website, www.bestwaycorp.com.
WARNING: Using an extension lead or multi plug adaptor with the spa heater can
cause the plug to overheat, causing damage to the equipment and surrounding
items. The spa is a class I electrical appliance and must be connected directly to a
grounded socket. It is recommended to only use a socket which is resistant to
humidity and capable of high power loading. Regularly check the plug and socket for
signs of damage before using the spa – do not use the spa if the plug or socket is
damaged. If you are unsure about the quality of the electrical supply, please consult
a qualified electrician before use.
SELECTED LOCATION
Due to the combined weight of the SaluSpa, water, and users, it is
extremely important that the surface where the SaluSpa is installed
GFCI WARNING
6