Using The Spa - Bestway SALUSPA MIAMI AIRJET Manuel De L'utilisateur

USING THE SPA

Hyperthermia occurs when the internal temperature of the body reaches a level
several degrees above the normal body temperature of 98.6°F(37°C). The symptoms
of hyperthermia include an increase in the internal temperature of the body,
dizziness, lethargy, drowsiness, and fainting. The effects of hyperthermia include
failure to perceive heat, failure to recognize the need to exit spa or hot tub,
unawareness of impending hazard, fetal damage in pregnant women, physical
inability to exit the spa or hot tub, and unconsciousness resulting in the danger of
drowning.
WARNING – The use of alcohol, drugs, or medication can greatly increase the risk of
fatal hyperthermia.
WARNING: WATER TEMPERATURE IN EXCESS OF 100°F(38°C) CAN BE
INJURIOUS TO YOUR HEALTH.
A. LOCK/UNLOCK BUTTON: The pump has a 5-minute auto-lock, this
light will turn on. To lock or unlock the pump, place a finger over the
lock/unlock button for 3 seconds.
B. POWER-SAVING TIMER BUTTON: Designed to help avoid wasting
power by setting the time and duration of the heating cycle for the spa.
This way, you can enjoy your spa at the time you desire, without needing
to leave the heater on at all times.
STEP 1: Set the heating duration
1. Press the
2. Press the
3. Press the
STEP 2: Set the number of hours FROM NOW when the heater will activate
1. After setting the heating duration, the
2. Press the
3. Press
LED will light steadily, and the countdown to heater activation will begin.
To modify the timer settings: Press the
Cancel the setting: Press the
NOTE: After setting, the screen flashes the current temperature and time alternately.
NOTE: Timer adjustment (amount of time with the heater ON) may be set from 1 to 999 hours;
Reservation time adjustment (the number of hours FROM NOW when the heater will begin to
function) may be set from 0 to 999 hours. If the timer is set at 0 hour, the heating system will
activate immediately.
Note that the timer is one time per use - the user sets the duration of the heating cycle, and
how many hours from now the heating cycle begins. The timer does NOT repeat until reset.
C. HEAT BUTTON: Use this button to activate the heating system. When
the light above the heat button is red, the heating system is activated.
When the light is green, the water is at the set temperature and the
heating system is at rest.
button unit the LED starts to flash.
or button to adjust the heating duration (From 1-999 hours).
button again to confirm the heating duration.
or button to adjust the hours until time of activation (From 0-999 hours).
button again or simply touch nothing for 10 seconds to confirm the setting. The
button for 2 seconds.
A
B
C
D
LED starts to flash.
button and use the
19
or button to adjust.
E
F
G
H
I