Pre-Installation Checklist - Bestway Steel Pro MAX Manuel Du Propriétaire

Pre-Installation Checklist

• The pool must be set up on a completely flat and level surface. Please
do not install the pool if the surface is inclined or sloped.
• The selected location must be capable of uniformly supporting the
weight for the entire time the pool is installed with water, moreover the
location must be flat, must be cleared of all objects and debris
including stones and twigs.
• The pool must be away from any objects children could use to climb
into the pool.
• Position the pool near an adequate drainage system to deal with
overflow or to discharge the pool. We recommend picking a location
that is at least 20ft. away from your home.
Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse causing serious personal
injury and/or damage to personal property and will void the warranty
and prevent any service claims.
• Sand should not be used to create a level base; the ground must be
dug out if necessary.
• Directly under overhead power lines or trees. Be sure the location
does not contain underground utility pipes, lines orcables of any kind.
• Do not set up the pool on driveways, decks, platforms, gravel or
asphalt surfaces. The selected location should be firm enough to
withstand the pressure of the water; Mud, sand, soft / loose soil or tar
are not suitable.
• Grass or other vegetation under the pool will die and may cause odors
and slime to develop, therefore we recommend removing all grass
from the selected pool location.
• Avoid areas prone to aggressive plant and weed species that may
grow through the liner.
Put 1in. to 2in. water in the pool to cover the floor. Once pool floor is slightly covered, gently smooth out all wrinkles. Start in the center of the pool
and work your way clockwise to the outside.
Pre-installation:
Bestway will not be responsible for damage caused to the pool due to
mishandling or failure to follow these instructions.
1. Lay out all parts and check that you have the correct quantities as
listed in the components list. For assistance or FAQs, please
visit the support section on our website, www.bestwaycorp.com.
2. Spread out the pool and make sure the pool is right side up, let it sit
exposed to direct sunlight for 1 hour or more so that the pool is more
flexible during set up.
3. Place the pool near an adequate drainage system to deal with
overflow water and ensure the pool's inlet A and outlet B are correctly
positioned to allow your filter pump to connect to a power source.
NOTES:
• Do not use extension power cords to power your pump.
• Do not drag the pool on the ground, this can damage the pool.
• Check with your local city council for by-laws relating to fencing,
barriers, lighting and safety requirements and ensure you comply with
all laws.
• If have a filter pump, refer to the pump's manual for instructions.
The ladder must match the pool size and should to be used only for
entering and exiting the pool. It is forbidden to exceed the permitted
payload of the ladder. Check regularly if the ladder is properly
assembled.
WARNING
smooth out the bottom
3